8.1 Configuring a stack

This section explains how to build a stack using configuration and operation commands and how to convert it to standalone mode.

<Structure of this section>

• 8.1.1 List of configuration and operation commands

• 8.1.2 Configuring a stack with standalone switches

• 8.1.3 Adding a member switch

• 8.1.4 Deleting a member switch (backup switch)

• 8.1.5 Deleting a member switch (master switch)

• 8.1.6 Replacing a member switch

• 8.1.7 Conversion to standalone

• 8.1.8 Adding a stack link

• 8.1.9 Deleting a stack link