8.1.1 List of configuration and operation commands
The following table lists the commands used to configure stacks.
Command name |
Description |
---|---|
stack enable |
Enables the stacking feature. |
switch priority |
Sets the master election priority. |
switch provision |
Sets the model of the member switches that make up the stack. |
switchport mode # |
Sets the port to connect between the member switches that make up the stack. |
- #
-
See "Configuration Command Reference Vol.1" "18 VLAN".
The following table describes the operation commands used to configure stacks.
Command name |
Description |
---|---|
set switch |
Sets the switch number of the member switch. |