30.3 Operation
The following tables list the operation commands for route filtering (IPv6).
Command name |
Description |
---|---|
show ipv6 route |
Shows the IPv6 unicast routes in the routing table. |
show ipv6 rip |
Shows information about the RIPng protocol. |
show ipv6 ospf |
Shows information related to the OSPFv3 protocol. |
show ipv6 bgp |
Shows information about the BGP4+ protocol. |
clear ipv6 bgp |
Clears BGP4+ sessions or BGP4+-related information, or filters inbound or outbound routes using new BGP filter information. |
show ipv6 vrf |
Displays the IPv6 information for VRFs. |
restart unicast # |
Restarts the unicast routing program. |
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".
- <Structure of this section>
-
-
30.3.1 Checking the routes received by RIPng (before learned route filtering)
-
30.3.2 Checking routes resulting from SPF calculations on OSPFv3 [SL-L3A]
-
30.3.3 Checking the routes received by BGP4 + (before learned route filtering) [SL-L3A]
-
30.3.4 Checking routes resulting from learned route filtering
-