Configuration Guide Vol. 3

28.2.2 Configuration flow

<Structure of this section>

(1) Setting the Stub Area for Non-Area Border

  1. Use the swrt_table_resource command to set the IPv6 resource.

    This step is required to perform IPv6 routing.

  2. Configure the IPv6 interfaces in advance.

  3. Configure the area to operate as a stub area.

  4. Enable OSPFv3.

(2) Area Border Router Configuration Procedure

  1. Use the swrt_table_resource command to set the IPv6 resource.

    This step is required to perform IPv6 routing.

  2. Configure the IPv6 interfaces in advance.

  3. Sets the area to operate as a stub area.

  4. Configure route summarization.

  5. Enable OSPFv3.

    Configure more than one area. At this time, you must configure an interface that connects to area 0 (the backbone), or establish a virtual link.

  6. Establish virtual links.

[Product name label]

All Rights Reserved, Copyright(C), 2017, 2023, ALAXALA Networks, Corp.