28.2.1 List of configuration commands
The following table shows the configuration commands for using a stub area and for operating as an area border router.
For details about the commands for the functions described in 27 OSPFv3, see Table 27-5: List of configuration commands related to advertising routes outside 27-4 AS, List of configuration commands related to route selection and route learning, and Table 27-6: List of configuration commands.
|
Command name |
Description |
|---|---|
|
area default-cost |
Sets the cost of the default route advertised to stub areas. |
|
area range |
Summarizes inter-area routes on an area border router under a single prefix for advertisement to other areas. |
|
area stub |
Configures an area as a stub area. |
|
area virtual-link |
Establishes a virtual link. |
|
Command name |
Description |
|---|---|
|
disable |
Disables OSPFv3. |
|
ipv6 ospf area |
Defines the domain number and area ID of the area in which OSPFv3 operates. |
|
router-id |
Assigns a router ID (to identify a specific router). |