23.2.2 Configuration flow for IPv6 DHCP servers

<Structure of this section>

(1) Setting to distribute a fixed prefix to clients

Use the swrt_table_resource command to enable IPv6.
Use the interface command to configure a VLAN interface.
Use the ipv6 address command to set an IPv6 address for the VLAN interface.
Use the ipv6 enable command to enable IPv6 on the VLAN interface and automatically generate an IPv6 address for the VLAN interface.
Configure a static prefix to each client.
Configure the distribution of prefixes to clients.
Configure the automatic generation of routes to clients to which prefixes are distributed.

Use the swrt_table_resource command to enable IPv6.
Use the interface command to configure a VLAN interface.
Use the ipv6 address command to set an IPv6 address for the VLAN interface.
Use the ipv6 enable command to enable IPv6 on the VLAN interface and automatically generate an IPv6 address for the VLAN interface.
Configure a range for dynamically distributing prefixes.
Configure the distribution of prefixes to clients.
Configure the automatic generation of routes to clients to which prefixes are distributed.

Use the swrt_table_resource command to enable IPv6.
Use the interface command to configure a VLAN interface.
Use the ipv6 address command to set an IPv6 address for the VLAN interface.
Use the ipv6 enable command to enable IPv6 on the VLAN interface and automatically generate an IPv6 address for the VLAN interface.
Configure the distribution of options to clients.