23.2.1 List of configuration commands

The following tables list the commands used to configure IPv6 DHCP servers.

Table 23-4: List of configuration commands
Command name	Description
dns-server	Sets the DNS server address used by the IPv6 DHCP server. The DNS server address is distributed to IPv6 DHCP clients upon request.
domain-name	Sets the IPv6 DHCP server domain name. The domain name is distributed to IPv6 DHCP clients upon request.
ipv6 dhcp pool	Sets information about an IPv6 DHCP address pool. [23.2.3 You can switch to the configuration DHCP mode. For example, you can set a fixed prefix for each client. For example, you can set a fixed prefix.
ipv6 dhcp server	Sets the distribution of prefixes. [23.2.5 Set Priority to Distribute Prefixes to Clients uses a server priority to distribute prefix priorities.
ipv6 dhcp static-route-setting	Automatically adds routing information to a client in a routing information table maintained on the Switch. A prefix is distributed to this client by the IPv6 DHCP server. [23.2.6 Used as shown in the example configuration in "Configuring automatic route generation for clients to which prefixes have been distributed".
ipv6 local pool	Sets a prefix to be assigned dynamically. [23.2.4 Use as shown in the example configuration in Dynamic Prefix Provisioning Range Configuration.
prefix-delegation	Sets a static IPv6 prefix, and the IAID and lifetime associated with the prefix to be stored in the specified IPv6 DHCP address pool. [23.2.3 Use as shown in the example configuration in "Configuring Per-Client Fixed Prefixes".
prefix-delegation pool	Sets the IAID and lifetime for the range of IPv6 prefixes specified in IPv6 DHCP address local pool setting. [23.2.4 Use as shown in the example configuration in Dynamic Prefix Provisioning Range Configuration.
service ipv6 dhcp	Enables or disables an IPv6 DHCP server.
sip-domain-name	Sets the SIP domain name provided by an IPv6 DHCP server. The DHCP server distributes the SIP domain name when it receives a request from an IPv6 DHCP client.
sip-server	Sets the IPv6 address of the SIP server provided by an IPv6 DHCP server. The DHCP server distributes the IPv6 address of the SIP server when it receives a request from an IPv6 DHCP client.
sntp-server	Sets the address of the SNTP server provided by the IPv6 DHCP server. The SNTP server address can be distributed to IPv6 DHCP clients upon request.