23.3.3 Route checking between MP

Use the l2traceroute command to obtain routing information about the route between the specified MPs and to display the result. You can specify the time to wait for a response and a TTL value for the command. By default, the time to wait for a response is set to 5 seconds, and the TTL value is set to 64.

The word Hit confirms that a response from the MP specified as the destination was received.

Figure 23-34: l 2 traceroute messages you see
>l2traceroute remote-mep 2010 domain-level 7 ma 1000 mep 2020 timeout 10 ttl 64 Date 20XX/03/15 14:05:30 UTC L2traceroute to MP:0012.e220.00a3 on Level:7 MA:1000 MEP:1020 VLAN:1000 Time:20XX/03/15 14:05:30 63 0012.e220.00c0 Forwarded 62 0012.e210.000d Forwarded 61 0012.e242.00a3 NotForwarded Hit

Figure 23-34: l 2 traceroute messages you see

>l2traceroute remote-mep 2010 domain-level 7 ma 1000 mep 2020 timeout 10 ttl 64
Date 20XX/03/15 14:05:30 UTC
L2traceroute to MP:0012.e220.00a3 on Level:7  MA:1000  MEP:1020  VLAN:1000
Time:20XX/03/15 14:05:30
63  0012.e220.00c0  Forwarded
62  0012.e210.000d  Forwarded
61  0012.e242.00a3  NotForwarded  Hit