23.3.4 Checking the Status of MP on a Route
You can use the show cfm l2traceroute-db detail command to check detailed information about the route to the destination MP and the MPs on the route. If the NotForwarded message is displayed, you can check the reason that the linktrace message was not forwarded in the Action section on the Ingress Port and the Egress Port lines.
> show cfm l2traceroute-db remote-mac 0012.e220.1040 detail Date 20XX/03/16 10:21:42 UTC L2traceroute to MP:2010(0012.e220.1040) on Level:7 MA:2000 MEP:2020 VLAN:20 Time:20XX/03/16 10:21:42 63 0012.e220.10a9 Forwarded Last Egress : 0012.f110.2400 Next Egress : 0012.e220.10a0 Relay Action: MacAdrTbl Chassis ID Type: MAC Info: 0012.e228.10a0 Ingress Port MP Address: 0012.e220.10a9 Action: OK Egress Port MP Address: 0012.e220.10aa Action: OK 62 0012.e228.aa3b NotForwarded Last Egress : 0012.e220.10a0 Next Egress : 0012.e228.aa30 Relay Action: MacAdrTbl Chassis ID Type: MAC Info: 0012.e228.aa30 Ingress Port MP Address: 0012.e228.aa2c Action: - Egress Port MP Address: 0012.e228.aa3b Action: Down > |