23.3.2 Verifying Connectivity Between MP

Use the l2ping command to check the connectivity between the specified MPs and to display the result. For the command, you can specify the number of verifications and the time to wait for a response. By default, the number of verifications is set to 5, and the time to wait for a response is set to 5 seconds. When a verification result is returned or the time to wait for a response has elapsed, another verification attempt is started.

Figure 23-33: l 2 ping messages you see
>l2ping remote-mep 1010 domain-level 7 ma 1000 mep 1020 count 3 timeout 1 L2ping to MP:1010(0012.e220.00a3) on Level:7 MA:1000 MEP:1020 VLAN:20 Time:20XX/03/14 19:10:24 1: L2ping Reply from 0012.e220.00a3 64bytes Time= 751 ms 2: L2ping Reply from 0012.e220.00a3 64bytes Time= 752 ms 3: L2ping Reply from 0012.e220.00a3 64bytes Time= 744 ms --- L2ping Statistics --- Tx L2ping Request : 3 Rx L2ping Reply : 3 Lost Frame : 0% Round-trip Min/Avg/Max : 744/749/752 ms >

Figure 23-33: l 2 ping messages you see

>l2ping remote-mep 1010 domain-level 7 ma 1000 mep 1020 count 3 timeout 1
L2ping to MP:1010(0012.e220.00a3) on Level:7  MA:1000  MEP:1020  VLAN:20
Time:20XX/03/14 19:10:24
1: L2ping Reply from 0012.e220.00a3  64bytes  Time=  751 ms
2: L2ping Reply from 0012.e220.00a3  64bytes  Time=  752 ms
3: L2ping Reply from 0012.e220.00a3  64bytes  Time=  744 ms
 
--- L2ping Statistics ---
Tx L2ping Request :    3  Rx L2ping Reply :    3  Lost Frame  :   0%
Round-trip Min/Avg/Max : 744/749/752 ms
 
>