14.1.4 Checking the switch's internal memory

Using the show flash operation command, you can check file system usage in the switch's internal memory. If the usage exceeds 95% of the total capacity, refer to the Troubleshooting Guide. An example is shown below:

Figure 14-5: Checking Flash size
> show flash Date 20XX/06/21 17:53:11 UTC Flash : user area config area dump area area total used 121,161kB 289kB 0kB 121,450kB free 14,619kB 75,117kB 65,390kB 155,126kB total 135,780kB 75,406kB 65,390kB 276,576kB >

Figure 14-5: Checking Flash size

> show flash
Date 20XX/06/21 17:53:11 UTC
Flash :
          user area   config area     dump area    area total
    used  121,161kB         289kB           0kB     121,450kB
    free   14,619kB      75,117kB      65,390kB     155,126kB
    total 135,780kB      75,406kB      65,390kB     276,576kB
>