15.1.5 Notes on using MC operation

(1) Coexistence with other functions

If both MC operational mode and zero-touch provisioning are enabled when the switch starts, this function is enabled and zero-touch provisioning is disabled.

(2) About Directories and Files Stored in MC

Do not add, change, or remove any software/device information saved in MC with the name shown in "Files saved in tabular 15-1 MC" by executing an operation command update mc-configuration or inserting a MC. Also, do not change the name.

(3) About inserting/removing MC

• When the Equipment is started up, MC is accessed because it is started by the software/information in MC. Do not disconnect MC until the startup of the device is completed.

• When a MC is inserted, the software/device data of the built-in flash memory is written to MC. Do not disconnect MC while ST2 LED is lit in green.

• Do not remove or insert MC while the operation command accessing MC is executing. MC may not be correctly inserted or removed.