12.1.4 Symmetric connection
- <Structure of this section>
(1) Connection type
The Switch connects symmetrically in active/passive mode to IP addressed unit specified by the configuration command ntp peer. It is not synchronized with the time of symmetric requestreceived from an unset IP.
Even if the host NTP server is disconnected, the system's time is synchronized by going through the symmetrically connected NTP server.
(2) Authentication
The following tables show the authentication keys that are assigned to NTP messages sent and received by the Switch to and from symmetric-connected devices.
Connection mode of this equipment |
Transmission from the Switch |
Reception by the Switch |
---|---|---|
Symmetric connection |
Authentication key specified in key parameter of the configuration command ntp peer * |
Any authentication key (authentication key set in the Switch configuration) |
- #
-
If you receive a NTP message with no credentials from a unicast client, send a reply message with no credentials.