activate bcu standby
装置起動後に待機系BCUを搭載した状態を含め,inactive状態の待機系BCUをactive状態にします。
[入力形式]
activate bcu standby
[入力モード]
一般ユーザモードおよび装置管理者モード
[パラメータ]
なし
[実行例]
> activate bcu standby > |
[表示説明]
なし
[通信への影響]
なし
[応答メッセージ]
メッセージ |
内容 |
---|---|
The command cannot be executed in the standby system. |
このコマンドは待機系では実行できません。 |
The command cannot be executed. Try again. |
コマンドを実行できません。再実行してください。 |
The command is not authorized by the RADIUS/TACACS+ server or the configuration. |
このコマンドはRADIUSサーバ,TACACS+サーバ,またはコンフィグレーションで承認されていません。 |
The standby BCU is not connected. |
待機系BCUは未搭載です。 |
The standby BCU is not inactive. |
待機系BCUはinactive状態ではありません。 |
[注意事項]
-
本コマンドは,プロンプトが戻るまで数秒間掛かります。