clear ipv6 urpf statistics
uRPFのIPv6統計情報を0クリアします。
[入力形式]
clear ipv6 urpf statistics clear ipv6 urpf statistics interface clear ipv6 urpf statistics interface <interface type> <interface number>
[入力モード]
一般ユーザモードおよび装置管理者モード
[パラメータ]
- interface
-
すべてのインタフェース単位でのuRPFのIPv6統計情報を0クリアします。
- interface <interface type> <interface number>
-
該当インタフェースのuRPFのIPv6統計情報を0クリアします。
<interface type> <interface number>には,次に示すインタフェース種別グループに対応するインタフェース名およびインタフェース番号を指定できます。詳細は,「パラメータに指定できる値」の「■インタフェースの指定方法」を参照してください。
-
イーサネットインタフェース
-
イーサネットサブインタフェース
-
ポートチャネルインタフェース
-
ポートチャネルサブインタフェース
-
VLANインタフェース
-
- すべてのパラメータ省略時の動作
-
装置全体でのuRPFのIPv6統計情報を0クリアします。
[実行例]
> clear ipv6 urpf statistics > |
> clear ipv6 urpf statistics interface > |
> clear ipv6 urpf statistics interface gigabitethernet 1/1 > |
[表示説明]
なし
[通信への影響]
なし
[応答メッセージ]
メッセージ |
内容 |
---|---|
The command cannot be executed in the standby system. |
このコマンドは待機系では実行できません。 |
The command cannot be executed. Try again. |
コマンドを実行できません。再実行してください。 |
The command is not authorized by the RADIUS/TACACS+ server or the configuration. |
このコマンドはRADIUSサーバ,TACACS+サーバ,またはコンフィグレーションで承認されていません。 |
The specified interface does not exist. |
指定したインタフェースは存在しません。指定パラメータを確認して再実行してください。 |
The specified interface type is incorrect. |
指定した<interface type>が不正です。指定パラメータを確認して再実行してください。 |
[注意事項]
なし