運用コマンドレファレンス Vol.3


clear ip urpf statistics

uRPFのIPv4統計情報を0クリアします。

[入力形式]

clear ip urpf statistics
clear ip urpf statistics interface
clear ip urpf statistics interface <interface type> <interface number>

[入力モード]

一般ユーザモードおよび装置管理者モード

[パラメータ]

interface

すべてのインタフェース単位でのuRPFのIPv4統計情報を0クリアします。

interface <interface type> <interface number>

該当インタフェースのuRPFのIPv4統計情報を0クリアします。

<interface type> <interface number>には,次に示すインタフェース種別グループに対応するインタフェース名およびインタフェース番号を指定できます。詳細は,「パラメータに指定できる値」の「■インタフェースの指定方法」を参照してください。

  • イーサネットインタフェース

  • イーサネットサブインタフェース

  • ポートチャネルインタフェース

  • ポートチャネルサブインタフェース

  • VLANインタフェース

すべてのパラメータ省略時の動作

装置全体でのuRPFのIPv4統計情報を0クリアします。

[実行例]

図4‒9 装置単位でのuRPFのIPv4統計情報0クリア
> clear ip urpf statistics
>
図4‒10 すべてのインタフェース単位でのuRPFのIPv4統計情報0クリア
> clear ip urpf statistics interface
>
図4‒11 指定インタフェースでのuRPFのIPv4統計情報0クリア
> clear ip urpf statistics interface gigabitethernet 1/1
>

[表示説明]

なし

[通信への影響]

なし

[応答メッセージ]

表4‒7 clear ip urpf statisticsコマンドの応答メッセージ一覧

メッセージ

内容

The command cannot be executed in the standby system.

このコマンドは待機系では実行できません。

The command cannot be executed. Try again.

コマンドを実行できません。再実行してください。

The command is not authorized by the RADIUS/TACACS+ server or the configuration.

このコマンドはRADIUSサーバ,TACACS+サーバ,またはコンフィグレーションで承認されていません。

The specified interface does not exist.

指定したインタフェースは存在しません。指定パラメータを確認して再実行してください。

The specified interface type is incorrect.

指定した<interface type>が不正です。指定パラメータを確認して再実行してください。

[注意事項]

なし