4.1 PORT
メッセージ種別PORTのシステムメッセージを次の表に示します。
メッセージ 識別子 |
イベント レベル |
メッセージテキスト |
---|---|---|
内容と対応 |
||
25010001 |
S6 |
The port status is Up. |
ポートがUPしました。 [対応] なし。 |
||
25010002 |
S5 |
Reception of frames at a port failed many times because of problems with the port. |
ノイズなどによるエラーのため,該当ポートでのフレーム受信失敗が多発しています。 [対応]
|
||
25010003 |
S5 |
Sending of frames to a port failed many times because of problems with the port. |
ノイズなどによるエラーのため,該当ポートでのフレーム送信失敗が多発しています。 [対応]
|
||
25010004 |
S6 |
The port was inactivated by configuration. |
コンフィグレーションコマンドshutdownによって,ポートを停止しました。 [対応] なし。 |
||
25010005 |
S6 |
The port was activated by configuration. |
コンフィグレーションコマンドno shutdownによって,ポートを起動しました。 [対応] なし。 |
||
25010006 |
S6 |
The port was inactivated by an operation command. |
inactivateコマンドによって,ポートを停止しました。 [対応] なし。 |
||
25010007 |
S6 |
The port was activated by an operation command. |
activateコマンドによって,ポートを起動しました。 [対応] なし。 |
||
25010010 |
S6 |
The port was inactivated by track. |
トラッキング連携によってポートを停止しました。 [対応] なし。 |
||
25010011 |
S6 |
The port was activated by track. |
トラッキング連携によってポートを起動しました。 [対応] なし。 |
||
25010101 |
S5 |
An error was detected on the port. |
ポートで障害を検出しました。 [対応] 10BASE-T/100BASE-TX/1000BASE-Tの場合
1000BASE-X/10GBASE-R/40GBASE-R/100GBASE-Rの場合
|
||
25010102 |
S5 |
The transceiver is not inserted properly. |
トランシーバの抜去を検出しました。 [対応] トランシーバが抜去された,または正しく挿入されていないおそれがあります。トランシーバが正しく挿入されているか確認してください。 |
||
25010103 |
S5 |
Auto-negotiation failed. |
オートネゴシエーションが失敗しました。 [対応]
|
||
25010104 |
S5 |
The unsupported transceiver was detected. |
未サポートのトランシーバを検出しました。 [対応]
|
||
25010105 |
S5 |
The inserted transceiver was detected. |
トランシーバの挿入を検出しました。 [対応] なし。 |
||
25010106 |
S1 |
The transceiver stopped because of a failure in its hardware. |
トランシーバでトランシーバ障害を検出しました。トランシーバを停止します。 [対応] トランシーバを交換してください。 |
||
35050208 |
S5 |
All ports were stopped, because there are not enough active SFUs. |
運用中のSFUが不足して本装置を経由するパケット中継ができなくなったため,全ポートを停止しました。 [対応] show systemコマンドでSFUの状態を確認してください。 |
||
35050209 |
S6 |
All ports were started, because there are enough active SFUs. |
運用中のSFUが増加して本装置を経由するパケット中継が可能になったため,全ポートを起動しました。 [対応] なし。 |
||
49310303 |
S3 |
The number of hierarchical shaper users exceeded the port capacity. |
階層化シェーパのシェーパユーザ数がポートの収容条件を超えています。収容条件を超えたシェーパユーザ番号のシェーパユーザは設定しません。 [対応] 該当ポートに設定した階層化シェーパのシェーパユーザリストのシェーパユーザ数を,収容条件以内にしてください。 |