運用コマンドレファレンス Vol.1
[機能]
回線の輻輳制御状態を運用状態に戻します。
[入力モード]
一般ユーザモードおよび装置管理者モード
[入力形式]
no cp congestion-control {nif <NIF No.> line <Line No.> | all}
[パラメータ]
- nif <NIF No.>
- 運用状態に戻すNIF 番号を指定します。指定できるNIF番号の値の範囲は,「パラメータに指定できる値」を参照してください。
- line <Line No.>
- 運用状態に戻すLine番号を指定します。指定できるLine番号の値の範囲は,「パラメータに指定できる値」を参照してください。
- all
- すべての回線について,輻輳制御状態を運用状態に戻します。
[実行例]
- show cp congestion-controlを実行します。
> show cp congestion-control 2005/03/18 13:00:10 congestion control service status:enable congestion control service control-time:30 seconds congestion control service start time:03/01 11:50:32 congestion control entries:1 congestion control exception-port: - congestion control exception-port congestion entries:0 ****** congestion control history(Most new Max 25entries) ****** NIF1/Line0 start time: 03/18 12:56:10 end time: now controlling ****** congestion control history(Most old Max 10entries) ****** NIF1/Line0 start time: 03/18 12:56:10 end time: now controlling ****** exception-port congestion history(Most new Max 25entries) ****** ****** exception-port congestion history(Most old Max 10entries) ******- 輻輳制御中のNIF1/Line0に対してno cp congestion-controlを実行します。
> no cp congestion-control nif 1 line 0 >- show cp congestion-controlを実行し,NIF1/Line0の輻輳制御が解除されていることを確認します。
> show cp congestion-control 2005/03/18 13:00:20 congestion control service status:enable congestion control service control-time:30 seconds congestion control service start time:03/01 11:50:32 congestion control entries:1 ****** congestion control history(Most new Max 25entries) ****** NIF1/Line0 start time: 03/18 12:56:10 end time: 03/18 13:00:15 ****** congestion control history(Most old Max 10entries) ****** NIF1/Line0 start time: 03/18 12:56:10 end time: 03/18 13:00:15 ****** exception-port congestion history(Most new Max 25entries) ****** ****** exception-port congestion history(Most old Max 10entries) ******
[ユーザ通信への影響]
あり
[応答メッセージ]
表14-17 no cp congestion-controlコマンドの応答メッセージ一覧
メッセージ 内容 Can't execute this command in standby BCU. このコマンドは待機系BCU上では実行できません。 Not operational CP. CPは非運用状態です。 No congestion-control NIF <NIF No.> Line <Line No>. 指定NIF/Lineは輻輳制御中ではありません。
<NIF No.>:NIF番号
<Line No>:Line番号Can't execute. コマンドを実行できません。
[注意事項]
なし
Copyright (c) 2005, 2011, ALAXALA Networks Corporation. All rights reserved.