32.1.2 Configuration flow

Refer to the setting examples below according to the configuration used.

Note that before IPv6 can be used, the swrt_table_resource command must be used to set the mode that allows IPv6 resources to be used. For more information about swrt_table_resource commands, see Configuration Command Reference Vol.1.

• When PIM-SM is used

  • Configuring IPv6 multicast routing

  • Configuring IPv6 PIM-SM

  • Configuring an IPv6 PIM-SM rendezvous point candidate (when using the local switch as a rendezvous point)

  • Configuring an IPv6 PIM-SM BSR candidate (when using the local switch as the BSR)

  • Configuring MLD settings

• When PIM-SM (static rendezvous point) is used

  • Configuring IPv6 multicast routing

  • Configuring IPv6 PIM-SM

  • Configuring an IPv6 PIM-SM rendezvous point candidate (when using the local switch as a rendezvous point)

  • Configuring an IPv6 PIM-SM static rendezvous point

  • Configuring MLD settings

• When PIM-SSM is used

  • Configuring IPv6 multicast routing

  • Configuring IPv6 PIM-SM

  • Configuring IPv6 PIM-SSM

  • Configuring MLD settings

• When PIM-SM is used in a VRF

  • Configuring IPv6 multicast routing for a VRF

  • Configuring IPv6 PIM-SM for a VRF

  • Configuring an IPv6 PIM-SM rendezvous point candidate for a VRF (when using the local switch as a rendezvous point in the target VPN)

  • Configuring an IPv6 PIM-SM BSR candidate for a VRF (when using the local switch as the BSR in the target VPN)

  • Configuring MLD for a VRF

• When PIM-SM (static rendezvous point) is used in a VRF

  • Configuring IPv6 multicast routing for a VRF

  • Configuring IPv6 PIM-SM for a VRF

  • Configuring an IPv6 PIM-SM rendezvous point candidate for a VRF (when using the local switch as a rendezvous point in the target VPN)

  • Configuring an IPv6 PIM-SM static rendezvous point for a VRF

  • Configuring MLD for a VRF

• When PIM-SSM is used in a VRF

  • Configuring IPv6 multicast routing for a VRF

  • Configuring IPv6 PIM-SM for a VRF

  • Configuring IPv6 PIM-SSM for a VRF

  • Configuring MLD for a VRF

• When PIM-SM is used for a VRF (extranet) (PIM-SM VRF gateway)

  • Configuring IPv6 multicast routing for a VRF

  • Configuring IPv6 PIM-SM for a VRF

  • Configuring an IPv6 PIM-SM rendezvous point candidate for a VRF (when using the local switch as a rendezvous point)

  • Configuring an IPv6 PIM-SM BSR candidate for a VRF (when using the local switch as the BSR)

  • Configuring a PIM-SM VRF gateway

• When PIM-SSM is used for a VRF (extranet)

  • Configuring IPv6 multicast routing for a VRF

  • Configuring IPv6 PIM-SM for a VRF

  • Configuring IPv6 PIM-SSM for a VRF

  • Configuring an IPv6 multicast extranet