32.1.1 List of configuration commands
The following tables list the commands used to configure IPv6 multicast.
|
Command name |
Description |
|---|---|
|
ipv6 mld fast-leave |
Enables the function that allows an MLD listener to immediately leave the group when the MLD listener is the only MLD listener on the same link. |
|
ipv6 mld group-limit |
Sets the maximum number of groups that an interface can join. |
|
ipv6 mld query-interval |
Changes the sending interval for query messages. |
|
ipv6 mld router |
Enables MLD. |
|
ipv6 mld source-limit |
Set the maximum number of sources when joining a group. |
|
ipv6 mld ssm-map enable |
Enables IPv6 PIM-SSM mapping operation to be used with MLDv1 or MLDv2 (EXCLUDE mode). |
|
ipv6 mld ssm-map static |
Sets the group address and source address for which PIM-SSM runs. |
|
ipv6 mld static-group |
Enables static additions to MLD groups. |
|
ipv6 mld version |
Changes the MLD version. |
|
ipv6 multicast-routing |
Enables use of the IPv6 multicast functionality. |
|
ipv6 pim |
Sets IPv6 PIM-SM. |
|
ipv6 pim assert-metric |
Changes the metric used in assert messages. |
|
ipv6 pim assert-preference |
Changes the preference value used in assert messages. |
|
ipv6 pim bsr candidate bsr |
Sets the BSR. |
|
ipv6 pim bsr candidate rp |
Sets the rendezvous point. |
|
ipv6 pim deletion-delay-time |
Changes the deletion delay time. |
|
ipv6 pim direct |
Enables the function that treats a remote multicast server address as a directly connected server. |
|
ipv6 pim hello-interval |
Changes the sending interval for hello messages. |
|
ipv6 pim join-prune-interval |
Changes the sending interval for join or prune messages. |
|
ipv6 pim keep-alive-time |
Changes the keep-alive time. |
|
ipv6 pim max-interface |
Changes the maximum number of interfaces that can run IPv6 PIM. |
|
ipv6 pim mcache-limit |
Specifies the maximum number of multicast forwarding entries. |
|
ipv6 pim mroute-limit |
Specifies the maximum number of multicast routing information entries. |
|
ipv6 pim negative-cache-time |
Changes the negative cache time. |
|
ipv6 pim register-probe-time |
Specifies the register probe time. |
|
ipv6 pim rp-address |
Sets the static rendezvous point. |
|
ipv6 pim rp-mapping-algorithm |
Specifies the rendezvous point selection algorithm. |
|
ipv6 pim ssm |
Sets the IPv6 PIM-SSM address. |
|
ipv6 pim vrf-gateway |
Sets the PIM-SM VRF gateway. |