27.5.1 List of operation commands

The following tables list the operation commands for OSPFv3.

Table 27-8: List of operation commands
Command name	Description
show ipv6 route	Shows the entries in the routing table.
clear ipv6 route	Clears the IPv6 forwarding entries stored in the Switch and re-registers the routing entries.
show ipv6 ospf	Shows OSPFv3 information such as the domain number, information about neighboring routers, interface information, and LSAs.
clear ipv6 ospf	Clears information about the OSPFv3 protocol.
show ipv6 vrf	Displays the IPv6 information for VRFs.
show ipv6 interface ipv6-unicast	Shows information about the IPv6 interfaces on the Switch recognized by the unicast routing program.
debug ipv6	Shows the packets being routed by IPv6 routing protocols in real time.
show processes cpu unicast^#	Shows the CPU usage of a unicast routing program.
restart unicast^#	Restarts the unicast routing program.
debug protocols unicast^#	Starts the operation message display for event log information output by a unicast routing program.
no debug protocols unicast^#	Stops the operation message display for event log information output by a unicast routing program.
dump protocols unicast^#	Outputs the trace information and control table information collected by the unicast routing program to a file.
erase protocol-dump unicast^#	Deletes the file of trace information and control table information generated by the unicast routing program.

#: See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".