Configuration Guide Vol. 3


26.3.4 Checking learned route information

<Structure of this section>

(1) Checking network units

Show routing information learned by RIPng in the specified network and stored in the routing tables.

Figure 26-11: Result of show ipv6 rip route
> show ipv6 rip route brief 4001::/16
Date 20XX/07/14 12:00:00 UTC
Status Codes: * valid, > active, r RIB failure
   Destination                              Interface      Metric Tag   Timer
*> 4001:21f7:2910:3029::/64                 VLAN0010       3      0      4s
*> 4001:64b9:4ba6:dd65::/64                 VLAN0020       4      0     10s
*> 4001:652c:7a78:c37::/64                  VLAN0020       3      0      9s
*> 4001:ddd9:158:9a2f::/64                  VLAN0010       5      0      4s

(2) Checking by gateway

Show per gateway the routing information received by RIPng in the specified network and stored in the routing tables.

Figure 26-12: Result of show ipv6 rip received-routes
> show ipv6 rip received-routes brief 4001::/16
Date 20XX/07/14 12:00:00 UTC
Status Codes: * valid, > active, r RIB failure
Neighbor Address: fe80::4048:47ff:fe10:10%VLAN0010
   Destination                              Interface      Metric Tag   Timer
*> 4001:21f7:2910:3029::/64                 VLAN0010       3      0      9s
*> 4001:ddd9:158:9a2f::/64                  VLAN0010       5      0      9s
Neighbor Address: fe80::4048:47ff:fe10:20%VLAN0020
   Destination                              Interface      Metric Tag   Timer
*> 4001:64b9:4ba6:dd65::/64                 VLAN0020       4      0     15s
*> 4001:652c:7a78:c37::/64                  VLAN0020       3      0     14s