24.2.2 Checking the route to the destination address

If you configure IPv6 unicast routing information in the Switch, use the show ipv6 route command to check whether a route to a specific destination address exists.

Figure 24-2: Show ipv6 route messages you see
> show ipv6 route Date 20XX/07/14 12:00:00 UTC Total: 11 routes Destination Next Hop Interface Metric Protocol Age 4000:110:1:1::/64 4000:110:1:1::1 VLAN0010 0/0 Connected 22m 53s cafe:1001::/64 4000:110:1:1::200 ..1 VLAN0010 0/0 Static 41s : : >

> show ipv6 route
Date 20XX/07/14 12:00:00 UTC
Total: 11 routes
Destination                                 Next Hop
      Interface      Metric   Protocol  Age
4000:110:1:1::/64                           4000:110:1:1::1
      VLAN0010       0/0      Connected 22m 53s
cafe:1001::/64                              4000:110:1:1::200            ..1
      VLAN0010       0/0      Static    41s
      :
      :
>

Check whether the command output contains a route corresponding to the destination address.