24.2.1 List of operation commands

show ipv6 route

Displays routing information stored in the routing table.

clear ipv6 route

Clears the IPv6 forwarding entries stored in the Switch and re-registers the routing entries.

show ipv6 interface ipv6-unicast

Shows information about the IPv6 interfaces on the Switch recognized by the unicast routing program.

debug ipv6

Shows the packets being routed by IPv6 routing protocols in real time.

show system ^#1

Displays operating status.

show processes cpu unicast ^#2

Shows the CPU usage of a unicast routing program.

restart unicast ^#2

Restarts the unicast routing program.

debug protocols unicast ^#2

Starts the operation message display for event log information output by a unicast routing program.

no debug protocols unicast ^#2

Stops the operation message display for event log information output by a unicast routing program.

dump protocols unicast ^#2

Outputs the trace information and control table information collected by the unicast routing program to a file.

erase protocol-dump unicast ^#2

Deletes the file of trace information and control table information generated by the unicast routing program.

show ipv6 interface ^#3

Shows the status of the IPv6 interface.

show netstat (netstat) (IPv6) ^#3

Shows the network status and statistics.

ping ipv6 ^#3

Tests connectivity by sending a test packet to an IPv6 address associated with a specific device.

traceroute ipv6 ^#3

Shows the route an IPv6 datagram travels to reach a destination host.