16.1.2 Configuration flow
Refer to the setting examples below according to the configuration used.
-
When PIM-SM is used
-
Configuring IPv4 multicast routing
-
Configuring IPv4 PIM-SM settings
-
Configuring an IPv4 PIM-SM rendezvous point candidate (when using the local switch as a rendezvous point)
-
Configuring an IPv4 PIM-SM BSR candidate (when using the local switch as the BSR)
-
Configuring IGMP settings
-
-
When PIM-SM (static rendezvous point) is used
-
Configuring IPv4 multicast routing
-
Configuring IPv4 PIM-SM settings
-
Configuring an IPv4 PIM-SM rendezvous point candidate (when using the local switch as a rendezvous point)
-
Configuring an IPv4 PIM-SM static rendezvous point
-
Configuring IGMP settings
-
-
When PIM-SSM is used
-
Configuring IPv4 multicast routing
-
Configuring IPv4 PIM-SM settings
-
Configuring IPv4 PIM-SSM
-
Configuring IGMP settings
-
-
When PIM-SM is used in a VRF
-
Configuring IPv4 multicast routing for a VRF
-
Configuring IPv4 PIM-SM for a VRF
-
Configuring an IPv4 PIM-SM rendezvous point candidate for a VRF (when using the local switch as a rendezvous point in the target VPN)
-
Configuring an IPv4 PIM-SM BSR candidate for a VRF (when using the local switch as the BSR in the target VPN)
-
Configuring IGMP for a VRF
-
-
When PIM-SM (static rendezvous point) is used in a VRF
-
Configuring IPv4 multicast routing for a VRF
-
Configuring IPv4 PIM-SM for a VRF
-
Configuring an IPv4 PIM-SM rendezvous point candidate for a VRF (when using the local switch as a rendezvous point in the target VPN)
-
Configuring an IPv4 PIM-SM static rendezvous point for a VRF
-
Configuring IGMP for a VRF
-
-
When PIM-SSM is used in a VRF
-
Configuring IPv4 multicast routing for a VRF
-
Configuring IPv4 PIM-SM for a VRF
-
Configuring IPv4 PIM-SSM for a VRF
-
Configuring IGMP for a VRF
-
-
When PIM-SM is used for a VRF (extranet) (PIM-SM VRF gateway)
-
Configuring IPv4 multicast routing for a VRF
-
Configuring IPv4 PIM-SM for a VRF
-
Configuring an IPv4 PIM-SM rendezvous point candidate for a VRF (when using the local switch as a rendezvous point)
-
Configuring an IPv4 PIM-SM BSR candidate for a VRF (when using the local switch as the BSR)
-
Configuring a PIM-SM VRF gateway
-
Configuring IGMP for a VRF
-
-
When PIM-SSM is used for a VRF (extranet)
-
Configuring IPv4 multicast routing for a VRF
-
Configuring IPv4 PIM-SM for a VRF
-
Configuring IPv4 PIM-SSM for a VRF
-
Configuring an IPv4 multicast extranet
-
Configuring IGMP for a VRF
-