16.1.1 List of configuration commands
The following tables list the commands used to configure IPv4 multicast.
|
Command name |
Description |
|---|---|
|
ip igmp group-limit |
Sets the maximum number of groups that an interface can join. |
|
ip igmp last-member-query-time |
Sets the number of seconds until the target group is deleted when a IGMPv2 Leave message or IGMPv3 Report (detachment request) message is received. |
|
ip igmp router |
Runs IGMP on the interface. |
|
ip igmp source-limit |
Set the maximum number of sources when joining a group. |
|
ip igmp ssm-map enable |
Set up to use IPv4 PIM-SSM linkage operation in IGMPv1/IGMPv2/IGMPv3(EXCLUDE). |
|
ip igmp ssm-map static |
Sets the group address and source address for which PIM-SSM runs. |
|
ip igmp static-group |
Enables static additions to IGMP groups. |
|
ip igmp version |
Changes the IGMP version. |
|
ip multicast-routing |
Enables the IPv4 multicast functionality to be used. |
|
ip pim accept-bootstrap |
Discards bootstrap messages received from the applicable interface. |
|
ip pim bsr-candidate |
Set BSR options. |
|
ip pim deletion-delay-time |
Changes the deletion delay time. |
|
ip pim fast-mcache-setting |
By distributing multicast routing information and negative cache deletion processing, packet processing in software is reduced, and the time required for hardware switching of multicast forwarding is reduced. |
|
ip pim keep-alive-time |
Changes the keep-alive time. |
|
ip pim max-interface |
Change the max. number of interfaces on which IPv4 PIM or IGMP will run. |
|
ip pim mcache-limit |
Specifies the maximum number of multicast forwarding entries. |
|
ip pim message-interval |
Changes the sending interval for join or prune messages. |
|
ip pim mroute-limit |
Specifies the maximum number of multicast routing information entries. |
|
ip pim multiple-negative-cache |
Specifies that the same (S, G) multiple negative cache entries can be created for each VLAN. |
|
ip pim negative-cache-time |
Changes the negative cache time. |
|
ip pim nonstop-forwarding |
Set this bit to continue multicast communication when the master switch fails. |
|
ip pim query-interval |
Changes the sending interval for hello messages. |
|
ip pim register-checksum |
Changes the checksum range for PIM-Register messages. |
|
ip pim register-probe-time |
Specifies the register probe time. |
|
ip pim rp-address |
Sets the static rendezvous point. |
|
ip pim rp-candidate |
Sets a rendezvous point candidate. |
|
ip pim rp-mapping-algorithm |
Specifies the rendezvous point selection algorithm. |
|
ip pim sparse-mode |
Sets the IPv4 PIM-SM. |
|
ip pim ssm |
Sets the IPv4 PIM-SSM address. |
|
ip pim vrf-gateway |
Sets the PIM-SM VRF gateway. |