14.3.2 Checking the routes received by RIP (before learned route filtering)

To check routes received by RIP, use the show ip rip operation command with the received-routes parameter specified.

Figure 14-3: Displaying RIP receive routes
> show ip rip received-routes Date 20XX/07/14 12:00:00 UTC Status Codes: * valid, > active, r RIB failure Neighbor Address: 192.168.1.145 Destination Next Hop Interface Metric Tag Timer *> 172.10.1/24 192.168.1.145 VLAN0007 1 0 23s

Figure 14-3: Displaying RIP receive routes

> show ip rip received-routes
Date 20XX/07/14 12:00:00 UTC
Status Codes: * valid, > active, r RIB failure
 
Neighbor Address: 192.168.1.145
   Destination        Next Hop        Interface      Metric   Tag   Timer
*> 172.10.1/24        192.168.1.145   VLAN0007       1        0     23s

Notes: The command output does not include routes that are excluded by learned route filtering or do not have priority under RIP.