14.3.1 List of operation commands
The following table lists the operation commands related to route filtering.
|
Command name |
Description |
|---|---|
|
show ip route |
Lists the IPv4 unicast routes in the routing table. |
|
show ip rip |
Shows information about the RIP protocol. |
|
show ip ospf |
Shows information about the OSPF protocol. |
|
show ip bgp |
Shows information about the BGP protocol. |
|
clear ip bgp |
Clears BGP4 sessions or BGP4-related information, or filters inbound or outbound routes using new BGP filter information. |
|
show ip vrf |
Displays IPv4 information in VRFs. |
|
restart unicast # |
Restarts the unicast routing program. |
|
dump protocols unicast # |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
|
erase protocol-dump unicast # |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".