13.5.6 Configuring route flap dampening
- <Structure of this section>
(1) List of configuration commands
The following table lists the commands used to configure route flap dampening.
Command name |
Description |
---|---|
bgp dampening |
Temporarily stops the use of an unstable route and reduces the effect of route flapping. # |
#: Only specified for the global network. The config-router mode setting is not applied to VRF.
(2) Configuring route flap dampening
- Points to note
-
The example below shows how to apply route flap dampening to a BGP4 route by using the bgp dampening command in config-router mode.
Command examples
-
(config)# router bgp 65531
(config-router)# bgp router-id 192.168.1.100
(config-router)# neighbor 172.16.2.2 remote-as 65532
(config-router)# neighbor 172.17.2.2 remote-as 65533
Configure the BGP4 peers.
-
(config-router)# bgp dampening
Applies route flap dampening.