8.2.2 Checking the route to the destination address

If you configure IPv4 unicast routing information in the Switch, use the show ip route command to check whether a route to a specific destination address exists.

Figure 8-9: Display show ip route Command-View
> show ip route Date 20XX/07/14 12:00:00 UTC Total: 13 routes Destination Next Hop Interface Metric Protocol Age 172.16/16 192.168.1.100 VLAN0010 2/0 RIP 8s ..1 192.168.1/24 192.168.1.1 VLAN0010 0/0 Connected 8s : : >

Figure 8-9: Display show ip route Command-View

> show ip route
Date 20XX/07/14 12:00:00 UTC
Total: 13 routes
Destination        Next Hop        Interface      Metric   Protocol  Age
172.16/16          192.168.1.100   VLAN0010       2/0      RIP        8s ..1
192.168.1/24       192.168.1.1     VLAN0010       0/0      Connected  8s
     :
     :
>

Check whether the command output contains a route corresponding to the destination address.