8.2.1 List of operation commands
The following tables list the operation commands that are common to IPv4 routing.
Command name |
Description |
---|---|
show ip route |
Displays routing information stored in the routing table. |
clear ip route |
Clears the IPv4 forwarding entries and re-registers the routing entries. |
show ip interface ipv4-unicast |
Shows information about the IPv4 interfaces on the Switch recognized by the unicast routing program. |
debug ip |
Shows the packets being routed by IPv4 routing protocols in real time. |
show system #1 |
Displays operating status. |
show ip interface #2 |
Shows the status of IPv4 interfaces. |
show netstat (netstat) (IPv4) #2 |
Shows the network status and statistics. |
ping #2 |
Tests connectivity by sending a test packet to an IPv4 address associated with a specific device. |
traceroute #2 |
Shows the route an IPv4 datagram travels to reach a destination host. |
show processes cpu unicast #3 |
Shows the CPU usage of a unicast routing program. |
restart unicast #3 |
Restarts the unicast routing program. |
debug protocols unicast #3 |
Starts the operation message display for event log information output by a unicast routing program. |
no debug protocols unicast #3 |
Stops the operation message display for event log information output by a unicast routing program. |
dump protocols unicast #3 |
Outputs the trace information and control table information collected by the unicast routing program to a file. |
erase protocol-dump unicast #3 |
Deletes the file of trace information and control table information generated by the unicast routing program. |
- #1
-
See "Managing Vol.1" "11 Appliance" in the Operation Command Reference.
- #2
-
See "Operation Command Reference Vol.2" "2 IPv4 .ARP .ICMP".
- #3
-
See "Operation Command Reference Vol.2" "9 IPv4 .IPv6 Routing Protocols".