7.1.1 Support Specifications
The following tables show the supported specifications for UDP broadcast relay on the Switch.
|
Category |
Lower sub-menu item |
Specifications |
|---|---|---|
|
Helper address |
IPv4 addressing that can be specified |
0.0.0.0 IPv4 addressing for the class A,B,C except /8 and 127.0.0.0/8 When a subnet broadcast address is specified, packets are broadcast to the corresponding network. |
|
Destination port number of the packet to be forwarded |
Port number that can be specified |
1~65535 |
|
Maximum rate |
1000 packets/sec for the entire switch |
|
|
Fragments of IP packets |
Receiving |
Fragmented packets are not rebuilt and are not forwarded. |
|
Sending |
The packets to be forwarded are fragmented according to DF. |
|
|
VRF-enabled |
The same VRF, and extranet # can be relayed between VLAN. |
|
- #
-
When using UDP broadcast relay in an extranet, use a configuration that uses route exchanges between VRF.