Configuration Guide Vol. 1


32.4.2 Checking MLD snooping

The following describes the MLD snooping contents to be checked when MLD snooping functionality is used.

<Structure of this section>

(1) After configuration setting

Execute the show mld-snooping command to check that the settings related to MLD snooping are correct.

Figure 32-4: Displays MLD snooping setting status.
> show mld-snooping 100
Date 20XX/02/01 15:20:00 UTC
VLAN: 100
  IP address: fe80::b1    Querier: enable
  MLD querying system: fe80::b1
  Querier version: V1
  IPv6 Multicast routing: Off
  Querier version: V2
  Port(5): 0/1-5
  Mrouter-port: 0/1,3
  Group Counts: 3

(2) Confirmation during operation

Execute the following command to check the status of MLD snooping during operation.