32.2.2 Checking IGMP snooping
The following describes the IGMP snooping contents to be checked when IGMP snooping functionality is used.
- <Structure of this section>
(1) Confirmation after configuration setting
Execute the show igmp-snooping command to check that the settings related to IGMP snooping are correct.
> show igmp-snooping 100 Date 20XX/10/01 15:20:00 UTC VLAN: 100 IP address: 192.168.11.20/24 Querier: enable IGMP querying system: 192.168.11.20 Querier version: V2 IPv4 Multicast routing: Off Fast-leave: On Port(5): 1/0/1-5 Mrouter-port: 1/0/1,3 Group Counts: 3 |
(2) Confirmation during operation
Execute the following command to check the status of IGMP snooping during operation.
-
Use the show igmp-snooping group command to check learned MAC addresses, IPv4 multicast addresses forwarded within a VLAN, and a list of forwarding destination port statuses.
Figure 32-2: Result of executing show igmp-snooping group command > show igmp-snooping group 100 Date 20XX/02/01 15:20:00 UTC VLAN counts: 1 VLAN: 100 Group counts: 3 IPv4 Multicast routing: Off Group Address MAC Address Version Mode 224.10.10.10 0100.5e0a.0a0a V2 - Port-list:1/0/1-3 225.10.10.10 0100.5e0a.0a0a V3 INCLUDE Port-list:1/0/1-2 239.192.1.1 0100.5e40.0101 V2,V3 EXCLUDE Port-list:1/0/1
-
Use the show igmp-snooping port command to check the participation group display example for each port.
Figure 32-3: Result of executing show igmp-snooping port command > show igmp-snooping port 1/0/1 Date 20XX/10/01 15:20:00 UTC Port 1/0/1 VLAN counts: 2 VLAN: 100 Group counts: 2 Group Address Last Reporter Uptime Expires 224.10.10.10 192.168.1.3 00:10 04:10 239.192.1.1 192.168.1.3 02:10 03:00 VLAN: 150 Group counts: 1 Group Address Last Reporter Uptime Expires 239.10.120.1 192.168.15.10 01:10 02:30