29.1.1 List of configuration commands
The following tables list Ring Protocol configuration commands.
|
Command name |
Description |
|---|---|
|
axrp |
Set a ring ID. |
|
axrp vlan-mapping |
Sets the VLAN mapping and VLANs participating in the mapping. |
|
axrp-primary-port |
Sets the primary port. |
|
axrp-ring-port |
Sets the ring port. |
|
control-vlan |
Sets the VLAN to be used as a control VLAN. |
|
disable |
Disables the Ring Protocol functionality. |
|
flush-request-count |
Sets the number of times flush control frames are sent. |
|
flush-request-transmit vlan |
Sets a VLAN that sends flush control frames for neighboring rings to devices in the neighboring ring. |
|
forwarding-shift-time |
Sets the reception hold time for flush control frames. |
|
health-check holdtime |
Sets the hold time for health check frames. |
|
health-check interval |
Sets the sending interval for health check frames. |
|
mac-clear-mode |
Set the target of MAC address table to be cleared by Ring Protocol function. |
|
mode |
Sets the operating mode for a ring. |
|
multi-fault-detection holdtime |
Sets the reception hold time for multi-fault monitoring frames. |
|
multi-fault-detection interval |
Sets the sending interval for multi-fault monitoring frames. |
|
multi-fault-detection mode |
Sets the monitoring mode for multi-fault monitoring. |
|
multi-fault-detection vlan |
Sets the VLAN used as the multi-fault monitoring VLAN. |
|
name |
Sets the name for identifying a ring. |
|
preempt-delay |
Enables the path switch-back suppression functionality and sets the suppression time. |
|
vlan-group |
Sets the VLAN group for which to run the Ring Protocol functionality, and the VLAN mapping ID. |