29.1 Configuration

To use the Ring Protocol functionality, axrp, axrp vlan-mapping, mode, control-vlan, vlan-group, and axrp-ring-port need to be set. Set the appropriate configuration for all nodes.

<Structure of this section>

• 29.1.1 List of configuration commands

• 29.1.2 Flow of Ring Protocol settings

• 29.1.3 Configuring ring IDs

• 29.1.4 Configuring control VLAN

• 29.1.5 Configuring VLAN mapping

• 29.1.6 Configuring a VLAN group

• 29.1.7 Configuring modes and ring ports (for single rings and multi-ring configurations without shared links)

• 29.1.8 Configuring modes and ring ports (for multi-ring configurations with shared links)

• 29.1.9 Configuring various parameters

• 29.1.10 Configuring the multi-fault monitoring functionality

• 29.1.11 Configuring flush control frames for neighboring rings