25.13.2 Checking VLAN extended functionality
- <Structure of this section>
(1) Checking VLAN communication status
The status of the settings for the VLAN extended functionality can be checked by using the show vlan detail command. The following table describes how to use the show vlan detail command to check the VLAN extended functionality.
Functionality |
How to check |
---|---|
VLAN tunneling |
VLAN tunneling enabled is displayed at the beginning of the results. |
Tag translation |
Tag-Translation is displayed for Port Information. |
L2 protocol frame transparency functionality |
Information is displayed in BPDU Forwarding and EAPOL Forwarding. |
>show vlan 10 detail Date 20XX/10/15 16:28:23 UTC VLAN counts:1 VLAN tunneling enabled ..1 VLAN ID:10 Type:Port based Status:Up Learning:On Tag-Translation:On BPDU Forwarding:On EAPOL Forwarding: ..3 . . . . Port Information 1/0/5 Up Forwarding Tagged Tag-Translation:1000 ..2 1/0/6 Down - Tagged Tag-Translation:2000 ..2 1/0/7 Up Forwarding Tagged > |
-
Indicates that VLAN tunneling is enabled.
-
Indicates that tag translation is set for this port.
-
Indicates that BPDU forwarding functionality is set and EAPOL forwarding functionality is not set.