20.4.2 Checking the Ethernet operating status

You can use the show port command to check the status of all Ethernet ports on the Switch. If you want to use an Ethernet port, confirm that up is displayed for Status of the port in the execution results. The following figure shows an example of the results of executing the show port command.

Figure 20-9: Result of executing show port command
> show port Date 20XX/11/21 15:16:19 UTC Port Counts: 24 Port Name Status Speed Duplex FCtl FrLen ChGr/Status 0/ 1 geth1/0/1 up 1000BASE-SX full(auto) off 1518 -/- 0/ 2 geth1/0/2 down - - - - -/- 0/ 3 geth1/0/3 up 100BASE-TX full(auto) off 1518 -/- 0/ 4 geth1/0/4 up 1000BASE-SX full(auto) off 1518 -/- : :

Figure 20-9: Result of executing show port command

> show port
Date 20XX/11/21 15:16:19 UTC
Port Counts: 24
Port  Name             Status   Speed       Duplex     FCtl FrLen ChGr/Status
 0/ 1 geth1/0/1        up       1000BASE-SX full(auto) off   1518   -/-
 0/ 2 geth1/0/2        down     -           -          -     -      -/-
 0/ 3 geth1/0/3        up       100BASE-TX  full(auto) off   1518   -/-
 0/ 4 geth1/0/4        up       1000BASE-SX full(auto) off   1518   -/-
      :
      :