2.11 MAC
This section describes the operation messages for the event location MAC.
Message ID |
Event Level |
Message text |
---|---|---|
Content and response |
||
20120002 |
E4 |
Channel Group(<channel group number>) is Up. |
The channel group status is Up. <channel group number>: Channel group number [Action] None. |
||
20120003 |
E4 |
Channel Group(<channel group number>) is Down - All port detached. |
All ports in the channel group are detached, and the channel group status is Down. <channel group number>: Channel group number [Action] For line connection status with partner switches:
|
||
20120004 |
E4 |
Channel Group(<channel group number>) is Down - The number of the detached port exceeded the configured number. |
The number of detached ports in the channel group exceeds the set limit, and the channel group status is Down. <channel group number>: Channel group number [Action] For line connection status with partner switches:
|
||
20120005 |
E3 |
Channel Group(<channel group number>) disabled administratively. |
A channel group was designated as disabled by the configuration. <channel group number>: Channel group number [Action] None. |
||
20120006 |
E3 |
Channel Group(<channel group number>) enabled administratively. |
A channel group was released from the disabled state by the configuration. <channel group number>: Channel group number [Action] None. |
||
20120007 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Different Partner System ID is detected. |
The system ID of a partner switch does not match between the ports for LACP mode link aggregation, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] Check the following:
|
||
20120008 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Different Partner Key is detected. |
The key of a partner switch does not match between the ports for LACP mode link aggregation, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] Check the following:
|
||
20120009 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) removed from Channel Group(<channel group number>). |
A port was detached from the channel group because of a configuration link deletion. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120010 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Port down. |
A line is down, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] Check the line status. |
||
20120011 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Different Port data rate. |
Lines that have different data rates (speeds) exist in the channel group. Lines that have low data rates were detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] For detached lines, check the settings of the Switch and partner switches. |
||
20120013 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Denied by the LACP partner. |
In LACP mode link aggregation, a connection from the partner switch was denied due to LACP, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] Check the partner switch status. |
||
20120014 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - LACPDU timeout. |
In LACP mode link aggregation, the port did not receive an LACPDU from the partner switch, and the port was detached from the channel group because of a timeout. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] Check the partner switch status, which is active. |
||
20120015 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Configuration is changed. |
A port was detached from the channel group because of a configuration change. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120016 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Port moved is detected. |
A port was detached from the channel group because the port was moved in the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120017 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Partner Aggregation bit is FALSE. |
The application bit of the partner switch in the LACP mode was false, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120018 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Partner Port number is changed. |
The port number of the partner switch was changed, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120019 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Partner Port priority is changed. |
The port priority value of the partner switch was changed, and the port was detached from the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120020 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - Operation of detach port limit. |
A port was detached from the channel group because of a detach port limit. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120021 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) added to Channel Group(<channel group number>). |
A port was added to the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120022 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) attached to Channel Group(<channel group number>). |
A port was aggregated to the channel group. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120023 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) attached to Channel Group(<channel group number>) - A standby port became active. |
Operation by a standby link has started. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |
||
20120024 |
E3 |
Port(<switch no.>/<nif no.>/<port no.>) detached from Channel Group(<channel group number>) - This port became a standby port. |
Operation by a standby link has started. <switch no.>/<nif no.>/<port no.>: Switch number/NIF number/port number <channel group number>: Channel group number [Action] None. |