29.7 Ring Protocol networking design

<Structure of this section>

• 29.7.1 Using VLAN Mapping

• 29.7.2 Using the Control VLAN's forwarding-delay-time

• 29.7.3 Automatic determination of the primary port

• 29.7.4 Mixed configuration of node types in the same device

• 29.7.5 Mixed configuration of node types on shared nodes

• 29.7.6 Setting the failure monitoring time when link aggregation is used

• 29.7.7 Combined use with IEEE802.3ah/UDLD function

• 29.7.8 Using with the link-down detection timer and the link-up detection timer

• 29.7.9 Prohibited Configuration of Ring Protocol

• 29.7.10 Prohibited configuration of multiple failure monitoring function

• 29.7.11 Configuration in which both ring ports of the master node are shared links

• 29.7.12 Setting the Fault Monitoring Time for Rings with Stacked Nodes