19.2.3 Suppressing the output of operation messages

When its status changes, the Switch displays an operation message containing operating data or fault data on the console or remote terminal. For example, a message might report that a line error has been restored, or that a line has failed and operation has stopped. For details about operation messages, see Message Log Reference and Operation Message 1.

Using the set logging console operation command, you can set an event level to limit the types of operation messages displayed. You can view the set event level by executing the show logging console operation command. The following setting example prevents operation messages up to event level E5 from being logged to the terminal.

> set logging console disable E5
> show logging console 
  System message mode : E5
>

Notes

When a large number of operation messages are generated in succession, only a portion of them will be shown on the console or remote terminal. To view all messages, use the show logging operation command.