19.2.1 Command list

The following table lists the commands used to configure the log output facility.

Table 19-1: List of configuration commands (settings for outputting syslog)
Command name	Description
logging event-kind	Sets the message type of the log data to be sent to syslog servers.
logging facility	Sets a facility to which log information is output via the syslog interface.
logging host	Sets the output destination for log information.
logging syslog-dump	Logs generated by the Switch are not stored in the on-chip flash memory.
logging syslog-version	Specifies the format version of syslog messages that are sent to syslog servers.
logging trap	Sets the level of importance for log information to be sent to the syslog server.

Table 19-2: List of configuration commands (settings for outputting E-Mail)
Command name	Description
logging email	Sets the email address to which log information is output as an email.
logging email-event-kind	Use E-Mail to set the message type of the log information to be output.
logging email-from	Sets the sender of the log information output as an email.
logging email-interval	Sets the interval for sending output log information as an email.
logging email-server	Sets the SMTP server information for outputting log information as an email.

The following table lists the operation commands related to the log output facility.

Table 19-3: List of operation commands
Command name	Description
show logging	Shows the log entries recorded by the Switch.
clear logging	Erases the log entries recorded by the Switch.
show logging console	Shows the contents set by the set logging console command.
set logging console	Controls the screen display of operation messages by event level.