2.4.1 0000XXXX

This section describes operation messages in which the upper four digits of the message identifier are 0000.

Table 2-4: Operation messages for event location SOFTWARE (0000XXXX)
Message ID	Event Level	Message text
Message ID	Content and response
00003003	E3	System restarted due to fatal error detected by software.
00003003	The software detected a fatal error and restarted the system. [Action] Check the log by executing the show logging command. If another problem is indicated in the log, take appropriate action according to the error message.
00003004	E3	System restarted due to user operation.
00003004	The Switch was restarted for one of the following reasons: Executing reload Commands Restarting the Network Interface Management Program [Action] Use show logging command to check the log. Then, check the cause of the device restart.
00003303	E3	Received many packets and loaded into the queue to CPU.
00003303	Numerous received packets have accumulated in CPU queues. [Action] None. However, if this message occurs frequently, check the following: Check whether packets destined for the local device, such as ping,telnet, broadcast packets, or multicast packets have been received in large volumes. If there is too much access from the network management device, limit the amount of access to the minimum necessary. Your network configuration may be too complex. Revise the network configuration.
00003304	E3	Processed the packets in the queue to CPU.
00003304	Packets that had been accumulating in CPU queues have been processed. [Action] None.
00008601	E3	NTP lost synchronization with <ip address>.
00008601	Synchronization was lost with the NTP server at <ip address>. <ip address>: IPv4 address of NTP server [Action] Use the show ntp associations command to check the NTP status. If the non-synchronized state continues, check the NTP configuration, NTP server operation status, and availability of communication.
00008602	E3	NTP detected an invalid packet from <ip address>.
00008602	An invalid packet from the NTP server at <ip address> was detected. <ip address>: IPv4 address of NTP server [Action] Check the NTP server.
00008603	E3	NTP could not find the server which synchronize with.
00008603	There is no NTP server for which synchronization is possible. [Action] Check the NTP configuration, NTP server operation status, and availability of communication.