26.2.1 Command list
The following table lists the commands used to configure Spanning Tree.
Command name |
Description |
---|---|
spanning-tree disable |
Stops the Spanning Tree functionality. |
spanning-tree mode |
Sets the operating mode for Spanning Tree functionality. |
spanning-tree single mode |
Selects STP and Rapid STP for Single Spanning Tree. |
spanning-tree vlan mode |
Selects PVST+ and Rapid PVST+ for each VLAN. |
The following table lists the operation commands related to Spanning Tree Protocol.
Command name |
Description |
---|---|
show spanning-tree |
Shows Spanning Tree information. |
show spanning-tree statistics |
Shows Spanning Tree statistics. |
clear spanning-tree statistics |
Clears Spanning Tree statistics. |
clear spanning-tree detected-protocol |
Forces recovery of STP compatible mode for Spanning Tree Protocols. |
show spanning-tree port-count |
Displays the numbers handled by Spanning Tree Protocols. |
restart spanning-tree |
Restarts the Spanning Tree program. |
dump protocols spanning-tree |
Outputs to a file detailed event trace information and control table information collected for Spanning Tree Protocols. |