21.2.2 Configuring static link aggregation
- Points to note
-
For static link aggregation, use the channel-group mode command to set the channel group number and on mode from the Ethernet interface configuration mode. Static link aggregation starts when these settings are set by the channel-group mode command.
Command examples
-
(config)# interface range gigabitethernet 1/0/1-2
Places the Switch in Ethernet interface configuration mode for configuring ports 1/0/1 and 1/0/2.
-
(config-if-range)# channel-group 10 mode on
Adds ports 1/0/1 and 1/0/2 to channel group 10 in static mode.