21.2.1 Command list
The following table lists the commands used to configure the basic link aggregation functionality.
Command name |
Description |
---|---|
channel-group lacp system-priority |
Sets the LACP system priority for each channel group. |
channel-group mode |
Adds a port to a channel group. |
channel-group periodic-timer |
Sets the LACPDU sending interval. |
description |
Sets supplementary information about a channel group. |
interface port-channel |
Sets up a port channel interface. The parameters of a channel group are also set in port channel interface configuration mode. |
lacp port-priority |
Sets the LACP port priority. |
lacp system-priority |
Sets the default for the LACP system priority. |
shutdown |
Stops communication for a channel group |
The following table describes the operation commands for link aggregation.
Command name |
Description |
---|---|
show channel-group |
Shows link aggregation information. |
show channel-group statistics |
Shows link aggregation statistics. |
clear channel-group statistics lacp |
Clears the statistics for sent and received LACPDUs. |
restart link-aggregation |
Restarts the link aggregation program. |
dump protocols link-aggregation |
Exports the detailed event trace information and control table information for link aggregation to a file. |