10.2.2 Configuring the System Clock
- Points to note
-
To set the switch's system clock, you must first set the time zone. Using the clock timezone configuration command, enter the appropriate country abbreviation for standard local time and specify the offset of +9 from UTC.
Command examples
-
(config)# clock timezone JST +9
Sets the JST time zone and an offset of +9 from UTC.
-
(config)# save
(config)# exit
Saves the settings and moves from configuration mode to administrator mode.
-
# set clock 2109011530
Wed Sep 1 15:30:00 JST 2021
Set the time at 15:30 on September 1, 2021.