10.2.1 Command list
The following tables list the configuration commands related to time setting and NTP.
Command name |
Description |
---|---|
clock timezone |
Sets the time zone. |
ntp access-group |
Creates an access group that can be permitted or denied access to NTP services by means of an IPv4 address filter. |
ntp authenticate |
Enables the NTP authentication functionality. |
ntp authentication-key |
Sets an authentication key. |
ntp broadcast |
Sends NTP packets by broadcast for each interface, and configures other switches to synchronize with the Switch. |
ntp broadcast client |
Specifies the setting for accepting NTP broadcast messages from devices on the connected subnet. |
ntp broadcastdelay |
Specifies the estimated latency (time delay) between the NTP broadcast server sending time information and the Switch. |
ntp master |
Sets the local time server. If there is no host NTP server, the Switch functions as a local time server and provides the time of the Switch to NTP clients. |
ntp peer |
Configure active/passive mode by symmetrically connecting NTP servers to the Switch. |
ntp server |
Set the Switch to client mode and configure client-server mode. |
ntp trusted-key |
Set the key number to authenticate for security purposes when synchronizing with other devices. |
The following tables list the operation commands related to time setting and NTP.
Command name |
Description |
---|---|
set clock |
Shows and sets the date and time. |
show clock |
Shows the current date and time. |
show ntp associations |
Displays the activity status of the connected NTP server. |
restart ntp |
Restarts the local NTP server. |