運用コマンドレファレンス Vol.3
指定されたインタフェースに設定されているIPv6アドレスの重複状態を解除して,Duplicate Address Detectionを再実行します。
[入力形式]
clear ipv6 duplicate-address interface <interface type> <interface number>
[入力モード]
一般ユーザモードおよび装置管理者モード
[パラメータ]
- interface <interface type> <interface number>
- 指定したインタフェースに設定されているIPv6アドレスの重複状態を解除して,Duplicate Address Detectionを再実行します。
- <interface type> <interface number>には,次に示すインタフェース種別グループに対応するインタフェース名およびインタフェース番号を指定できます。詳細は,「パラメータに指定できる値」の「■インタフェースの指定方法」を参照してください。
- イーサネットインタフェース
- イーサネットサブインタフェース
- ポートチャネルインタフェース
- ポートチャネルサブインタフェース
- VLANインタフェース
- マネージメントポート
[実行例]
図3-9 IPv6アドレスの重複状態解除およびDuplicate Address Detection再実行
> clear ipv6 duplicate-address interface gigabitethernet 1/1 >
[表示説明]
なし
[通信への影響]
なし
[応答メッセージ]
表3-10 clear ipv6 duplicate-addressコマンドの応答メッセージ一覧
メッセージ 内容 The command cannot be executed in the standby system. このコマンドは待機系では実行できません。 The command cannot be executed. Try again. コマンドを実行できません。再実行してください。 The command is not authorized by the RADIUS/TACACS+ server or the configuration. このコマンドはRADIUSサーバ,TACACS+サーバ,またはコンフィグレーションで承認されていません。 The specified interface does not exist. 指定したインタフェースは存在しません。指定パラメータを確認して再実行してください。 The specified interface type is incorrect. 指定した<interface type>が不正です。指定パラメータを確認して再実行してください。
[注意事項]
- 本コマンド実行後にアドレスの重複状態を確認する場合は,show ipv6 interfaceコマンドまたはshow ip-dual interfaceコマンドを実行してください。
- 本コマンドを実行すると,次のアドレスに対してDuplicate Address Detectionが再実行されます。
- Duplicate Address Detectionを実行中のため使用できる状態になっていないIPv6アドレス
- 重複を検出して使用できない状態になったIPv6アドレス
All Rights Reserved, Copyright(C), 2014, 2020, ALAXALA Networks, Corp.