コンフィグレーションコマンドレファレンス Vol.1
表19-12 SFU/PSU/NIFの管理設定時のエラーメッセージ
メッセージ 内容 The 'service-type' cannot be deleted because 'shaper mode' has been set. 階層化シェーパモードが設定されているため,サービスタイプは削除できません。階層化シェーパモードを削除してから,サービスタイプを削除してください。 The board type cannot be deleted because the NIF number of the board type is configured for the pe-service mode. 指定したボードタイプのNIF番号がpe-serviceモードに設定されているため,ボードタイプを削除できません。
PEサービスに設定されているNIF番号を削除してください。The NIF number is already configured for another pe-service mode. 指定したNIF番号は別のpe-serviceモードですでに設定されています。
ほかのPEサービスに設定されているNIF番号を削除してください。The NIF number is not configured for a PE-NIF board type. 指定したNIF番号はボードタイプにPE-NIFが設定されていません。 The specified NIF number cannot be deleted because 'shaper mode' has been set. 指定したNIF番号は,階層化シェーパモードが設定されているため削除できません。階層化シェーパモードを削除してから,NIF番号を削除してください。 The TPID cannot be set to the port on PE-NIF. PE-NIF内のポートには,TPIDを設定できません。
All Rights Reserved, Copyright(C), 2014, 2020, ALAXALA Networks, Corp.